Source: gfxdetect
Section: contrib/utils
Priority: extra
Maintainer: Joerg Schirottke <master@kanotix.com>
Build-Depends: debhelper (>= 7.0.50~)
Standards-Version: 3.8.4
Homepage: http://kanotix.com

Package: gfxdetect
#Architecture: any
#Depends: nvidia-driver, nvidia-settings, vdpau-va-driver, libgl1-nvidia-glx-ia32 [amd64],
#         fglrx-driver, fglrx-modules-dkms, xvba-va-driver, fglrx-atieventsd, fglrx-control, fglrx-glx-ia32 [amd64],
#         i965-va-driver, vainfo
Architecture: all
Depends: nvidia-driver, nvidia-settings, vdpauinfo,
         i965-va-driver, vainfo
Recommends: fglrx-driver, fglrx-modules-dkms, libfglrx-amdxvba1, fglrx-atieventsd, fglrx-control
Description: autodetect gfx card on start and enable binary driver
 all settings required to switch the gfx driver are done in the initrd
 depends on nvidia and fglrx binary drivers
 allows custom xorg.conf for each binary driver or per card
 config files used if installed (not in this package):
  /etc/X11/xorg.conf.default
  /etc/X11/xorg.conf.nvidia
  /etc/X11/xorg.conf.fglrx
  /etc/X11/xorg.conf.vvvvdddd
 vvvv = pci id vendor (lowercase)
 dddd = pci id device (lowercase)
 If vvvvdddd config file is there it is used,
 if not the driver specific files is used,
 if no nvidia/fglrx is found the default is used,
 if no default file exists no xorg.conf is used.
 If nvidia/fglrx is found but no config file a minimal config is written.
 To active on hd install add "gfx=on rw" to GRUB_CMDLINE_LINUX_DEFAULT
 in /etc/default/grub and run:
  update-grub
  update-initramfs -utk all
